(833) 353-2870
(833) 353-2870
The MIGRO Mi-Fi Smart Controller is designed for use in various applications. The Controller is rated for 120VAC or 240VAC systems with up to 30 AMP Loads. Through the Mobile application the controller can be managed by the user, schedules and it is also compatible with most iOT systems including, Google Home, Alexa, and IFTTT. Applications can vary from home automation to commercial/industrial controls.
ELECTRICAL SAFETY: System shall be installed and used in accordance with local electrical codes and regulations.
Your Wi-Fi control system must be installed and maintained as described in this guide to ensure reliable and safe operation. Confirm the voltage and current draw of your connected load to the control output is consistent with the design specifications of this product and that your application will not exceed the maximum load capacity listed.
WI-FI ENABLED CONTROLS: Use mobile apps as well as Google and Alexa to your system on/off or scheduling.
MANUAL ON MODE: “Manual ON” mode will give you the ability to run your system regardless of the Wi-Fi control status.
BEYOND SCHEDULING: Use the Google, Alexa and IFTTT capabilities to control your systems by weather, workflow Geo-fencing, and others.
OVERRIDE OFF MODE: This mode provides users with great safety protection. The OFF mode will remain OFF regardless of Wi-Fi controls.
Additional Data
Power Supply: 100-250VAC
Relay: DPST
Security: WEP/WPA-PSK/WPA2-PSK
FCC Part 15 IEEE 802.11 b/g/n
Wi-Fi Frequency: 2.412-2.48GHz
Contact Resistance: 100mΩ
Contact Material: Silver alloy – AgCdO, AgSnO2, AgNi
Contact Rating (Inductive): 1HP/16A/120VAC; 20A/250VAC
Contact Rating (Resistive): 30A/250VAC
Max Switching Voltage: 250VAC
Max Switching Current: 30A
Max Switching Power: 7200VA
Ensuring your MIGRO Mi-FI Smart Switch is functioning prior to field installation is required by the manufacturer. Environmental and application specific conditions may cause communication error and a bench test will ensure that the equipment is functioning properly. Connect a 120 or 240VAC Power Supply to the System and perform the pairing steps to ensure connection. (see pairing instructions below)
1. CONDUIT FITTING – Install the conduit fitting provided (or one provided elsewhere) in the desired location ensuring wire clearance within the enclosure.
2. ANTENNA – Install the Antenna provided onto the threaded connector located on the outside of the enclosure.
3. MOUNT TO DESIRED LOCATION – Place and mount the enclosure to your desired location using the supplied hardware. The brackets are to be mounted to the back exterior of the enclosure with the wall flanges facing out. (See Image 1)
4. WIRE THE SYSTEM – Wire in accordance with the national and local electrical codes (see Wiring Diagram). After wiring is complete, turn circuit power on and test your MIGRO Mi-Fi Switch.
