Ensuring your MIGRO Smart Wi-Fi Controller is functioning prior to field installation is required by the manufacturer. Environmental and application specific conditions may cause communication error and a bench test will ensure that the equipment is functioning properly. Connect a 240VAC Power Supply to the System and perform the pairing steps to ensure connection. (see pairing instructions below)
Your Wi-Fi control system must be installed and maintained as described in this guide to ensure reliable and safe operation. Conﬁrm the voltage and current draw of your connected load to the control output is consistent with the design speciﬁcations of this product and that your application will not exceed the maximum load capacity listed.
WI-FI ENABLED CONTROLS: Use mobile apps as well as Google and Alexa to your system on/off or scheduling.
MANUAL ON MODE: “Manual ON” mode will give you the ability to run your system regardless of the Wi-Fi control status.
BEYOND SCHEDULING: Use the Google, Alexa and IFTTT capabilities to control your systems by weather, workflow Geo-fencing, and others.
OVERRIDE OFF MODE: This mode provides users with great safety protection. The OFF mode will remain OFF regardless of Wi-Fi controls.
Power Supply: 220/240VAC
FCC Part 15 IEEE 802.11 b/g/n
Wi-Fi Frequency: 2.412-2.48GHz
50 A. Incandescent or Resistive Load AC1
40 A. Ballast and General Purpose AC3
10HP @ 240V, 15 KW 277VAC
40 A. Ballast 7KW @ 220VAC
1. CONDUIT FITTING – Install the conduit fitting provided (or one provided elsewhere) in the desired location ensuring wire clearance within the enclosure.
2. ANTENNA – Install the Antenna provided onto the threaded connector located on the outside of the enclosure.
3. MOUNT TO DESIRED LOCATION – Place and mount the enclosure to your desired location using the supplied hardware. The brackets are to be mounted to the back exterior of the enclosure with the wall flanges facing out. (See Image 1)
4. WIRE THE SYSTEM – Wire in accordance with the national and local electrical codes (see Wiring Diagram). After wiring is complete, turn circuit power on and test your MIGRO Smart Wi-Fi Controller.
Manual Override: Momentarily press the small BLACK button located on the white Sonoff smart Wi-Fi switch module.